The first thing to do when getting a new phone: Why is it recommended to post Hujingtie first and then talk about anything else
Guide
The longer the glass surface of a new machine is exposed, the higher the risk of dust accumulation and micro-scratches. Three key points for the first application: a low-dust environment, a three-piece dust removal set, and positioning first before releasing the release film.
01. Timing: Why is it recommended to stick it as soon as possible
The bare screen stage is a window with a relatively high risk of scratches: pocket dust, desktop particles, and hard particles on the wiping cloth will all leave long-term micro-scratches during the "first use for a few days" hesitation period. The earlier the film is applied, the higher the integrity of the substrate will be.
Another reason is verification: After the new film is applied, the circular polarization can be verified with the included test card (rotate the white screen for observation), and the technical configuration can be confirmed immediately.
02. Three key points for the first post operation
Environment: After hot water spray in the bathroom (water vapor for dust suppression) or in a low-dust room, turn off the fan. Dust removal: Wipe with a wet wipe → clean with a dry wipe → Remove residual particles with dust removal stickers. These three steps cannot be omitted. Method: First, position through the earpiece/camera hole. After confirming alignment, gradually release the release film while pushing and pressing with a scraper card.
For the 3D heat-bent type (Guanfudun Qu), please note: First align the center, then press and spread it towards the arc surfaces on both sides to allow the adhesive layer to naturally extend along the curvature.
03. One week after Posting
It takes about 24 to 72 hours for the adhesive layer to fully stabilize. During this period, a slight "unadhered feeling" at the edge is normal. Avoid immediately installing an overly tight protective case and squeezing the edge. If there are dust bubbles or obvious misalignment that cannot be eliminated within a week, contact after-sales service for replacement. There is no need to make do.
During the new device stage, it is also worth doing: set the screen brightness to be adaptive and check the system night view - only when the device and system Settings are coordinated can the experience be complete.