Magnetron sputtering AR coating: What makes the anti-reflection process so strong
What does this article talk about?
There are three routes for anti-reflective (AR) coating: water bath, electron beam, and magnetron sputtering. This article clarifies why magnetron sputtering can reduce the reflectivity to the typical value of ≤0.5% and maintain stability between batches, as well as how it improves the viewing experience outdoors and in strong light.
Anti-reflective (AR) coating is not a new concept, but the process route determines the upper limit of the effect. There are three mainstream methods: chemical immersion, electron beam evaporation and magnetron sputtering, and they vary greatly.
Ceiling with high reflectivity.The reflectivity of ordinary tempered film is about 4%, which is equivalent to the screen always being covered with a mirror surface. The solution soaking process accounts for approximately 3%, and electron beam evaporation for about 2%. Vacuum magnetron sputtering of inorganic AR can be reduced to around 0.5% (Guanfudun typical ≤0.5%, laboratory measurement), approaching the level of the original multi-layer AR film system.
Why is magnetron sputtering superior?It bombards the target material with ions in a vacuum environment, evenly sputtering inorganic materials onto the glass surface. The coating is dense, has strong adhesion and controllable thickness. Compared with the uneven soaking in chemical solutions and the lower density of electron beams, magnetron sputtering has more stable anti-reflection and is also more wear-resistant.
Direct benefits in terms of experience.It has a low reflectivity, significantly reducing the glare under outdoor backlighting and indoor ceiling lights. You don't have to squint or turn the brightness up to the maximum. At the same time, the haze remains low (measured by SGS at 0.4%), and the picture is neither white nor transparent.
How to recognize when making a purchase.Check if it is marked as "Vacuum magnetron sputtering AR" and if the reflectance value and data source are provided. Guanfudun integrates magnetron sputtering AR with scinique® circularly polarized light layers to form a dual structure of "inner soft light + outer anti-reflection", which is a complete solution in terms of process.
Related reading:scinique® Dual-Protection Synergistic Optical Technology | Guanfudun product page | SGS Test report
What are the common problems?
Q1: How much is the difference in reflectivity among the three AR processes?
For ordinary films, it is approximately 4%; for chemicals, it is about 3%; for electron beams, it is around 2%; and for magnetron sputtering, it can reach around 0.5%. Magnetron sputtering is significantly lower and more stable.
Q2: What are the advantages of magnetron sputtering over immersion in chemicals?
The coating is denser and more uniform, with strong adhesion, more stable anti-reflection and wear resistance. It is not a consumable process like surface coating.
Q3: What are the physical sensations when the reflectivity is low?
Glare is reduced under outdoor and indoor lighting, so there is no need to squint or increase the brightness, and the picture is more transparent.
Q4: How to confirm the use of magnetron sputtering?
Check if the parameters are marked with "vacuum magnetron sputtering AR" and provide the reflectance value and source. It is more reliable to supplement it with detection cards and third-party data.
